Page 1 of 1
Dual carb manifold
Posted: Fri 04 May 2018, 10:29
by getafix
Dual weber - downdraft - setup wanted for ford V6. As complete as possible. Was this the interceptor configuration??
Re: Dual carb manifold
Posted: Mon 07 May 2018, 16:02
by Shaunp
The interceptor had triple carbs. The twin carb manifold you can get from Roland manifolds in cpt.
Sent from my SM-G935F using Tapatalk
Re: Dual carb manifold
Posted: Tue 08 May 2018, 18:41
by getafix
Had a look at the Roland website. Picture on there is scary - manifold quality looks to be under par. VW forum reckons to stay away from them. Burton power in UK has got a nice setup but ZAR/GBP exchange rate ruled that out very quickly.
Re: Dual carb manifold
Posted: Tue 08 May 2018, 21:12
by ZA Perana
getafix wrote: ↑Tue 08 May 2018, 18:41
Had a look at the Roland website. Picture on there is scary - manifold quality looks to be under par. VW forum reckons to stay away from them. Burton power in UK has got a nice setup but ZAR/GBP exchange rate ruled that out very quickly.
I have seen a few roland manifolds and the quality is ok, they are well experienced with Ford V6's.
Re: Dual carb manifold
Posted: Wed 09 May 2018, 18:56
by Shaunp
Interceptor kit is pricey. You also get the xocet/Holley carb with muscle intake as well the ego set up.
Sent from my SM-G935F using Tapatalk
Re: Dual carb manifold
Posted: Thu 10 May 2018, 20:54
by goddard
If you looking to spice up a pretty standard 3l v6, go with the dual carbs (the Roland manifolds are tried and tested) a good alternative is the single 4 barrel Holley as found on the Xocet. (the Xocet made more power than the Interceptor with its triple carbs)
The triple carbs was not very well thought out, they never work well on a standard 3l, but, they CAN work well on a big bore stroker v6...
back in the day I used to run against Interceptors with my Cortina Xle (with twin carbs and branches) don't think any interceptor crossed the line within 4 cars lengths behind me.
Re: Dual carb manifold
Posted: Fri 11 May 2018, 06:31
by Shaunp
Shaunp wrote:Interceptor kit is pricey. You also get the xocet/Holley carb with muscle intake as well the ego set up.
Sent from my SM-G935F using Tapatalk
" efi"
Sent from my SM-G935F using Tapatalk
Re: Dual carb manifold
Posted: Thu 17 May 2018, 19:41
by getafix
EFI would be nice to have. Any one there manufacturing EFI manifolds?
Re: Dual carb manifold
Posted: Fri 18 May 2018, 07:22
by RASSIE
Balanced V6, gas flow heads, 79 cam, 4 barrel intake and 390 Holley and you run like the wind!!
Rassie.