Good day guys
I have a Cobra with a 351W and 21R gearbox setup.
Bought the car having a clutch shudder and had the clutch and pressure plate reconned .
The clutch felt better with no shudder but under acceleration the clutch was slipping and could only get it to engage if I gently squeezed the accelerator.
This lasted just a few days and the pressure plate collapsed.
I am in need of matching up a new clutch and pressure plate.
The Toyota d4d kit would work but the clutch plate does not seat flush on the flywheel and the diameter across the centre of the clutch plate is too wide for the gap in the centre of the flywheel.
i can source an original kit for the 351 but the splines on the clutch plate wont work.
Can this be swopped out on the old clutch plate( Toyota ) to be used on the Ford clutch plate?
From what I believe the setup I had was Toyota Dyna but we cannot find the correct kit.
Can anyone advise on a standard clutch kit we can source or what is the best option going forward?
TIA
351W CLUTCH SETUP
Forum rules
Please the introduction first.
When posting topics on the forum please make sure:
Please the introduction first.
When posting topics on the forum please make sure:
- ● The posts are not political
- ● The posts are not about religion
- ● Please keep posts civil and don't be nasty to other members
Re: 351W CLUTCH SETUP
Bit late in my response, sorry. You may find best taking all the parts to FeroBrake to let them match up what fits.
Nothing is as it seems!
Social Media
Who is online
Users browsing this forum: No registered users and 3 guests